RailCore II 300ZL Kit
View
Options
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
Introduction
Details
Guide Steps
Review
Quiz
There is a long green ground cable used for grounding the frame. It has ring terminals on one end.
One end goes in the same 5 port WAGO as used for the bed ground, Power Inlet Ground, and PSU ground (green wires)
Run the cable up past the SSR, and attach it to the top frame on the extrusion near the rear stepper.
Use the toothed lockwasher and an M3 x 8mm button head bolt. Place the toothed washer under the ring terminal.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.