Photos of these steps will be added ASAP
You'll need to remove the wiring that came pre-installed on the BLTouch if you haven't already. The wiring harness includes a new BLTouch connector.
Connect the hotend, hotend fan, thermistor, BLTouch, and the Fan/Y Endstop.
You may need to pull the wires further through the wiring harness in one direction or the other to make them reach, or to reduce slack. You don't want them super taught, but you don't want a lot of slack on the extruder end once they're connected.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.