The top and left panels are pictured for reference - they're not actually installed yet because it makes the wiring much easier to route.
Install the grommet in the panel, to keep the wires from rubbing. If you've already pulled any of the wires through, you'll need to remove them to add the grommet.
Both the wire bundle from the bed, and from the hotend, will run through this hole.
Install the Ribbon Cable between the Duet & Duex5. Note the red strip should go to the right.
You can tuck the excess length of the ribbon cable under the Duex5 to help keep things tidier.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.