Difficulty
Moderate
Steps
2
Time Required
- K) Y Carriage 2 steps
In Progress
This guide is currently being written. Reload periodically to see the latest changes.
User-Contributed Guide
This guide is not managed by the site's staff.
Private
This guide will not appear in search results and can only be viewed by team members!
Tools
No tools specified.
Parts
- Mini Harness W16
- Printed Mini Y Carriage
- Printed Layer Fan Adapter
- BLTouch Sensor
- M3 Washer × 2
- Y Endstop Mount
- M3 Brass Insert × 2
- M3 x 20 Socket Head Screw × 2
- M3 x 8 Socket Head Screw × 4
- M2 Nut × 2
- M2 x 12mm Bolt
- M3 Nut
- M3 x 6mm button head bolt
- M3 x 12mm Button Head Bolts
- M3 x 8mm Button Head Bolt
- M3 Nylock Nut × 2
-
-
Remove the wiring that comes pre-installed on the bltouch by disconnecting the connector. The kit wiring harness has a connector, these wires are not needed.
-
Put (2) m3 x 2 socket head screws pointing up through the holes in the BLTouch.
-
Thread a brass insert down on the bolt, tight against the BLTouch.
-
Pass the bolt up through the BLTouch mount.
-
Put a single M3 washer on each screw, and then an M3 nylock nut.
-
Attach the BLTouch mount to the printed Y carriage using (2) M3 x 8 socket head screws.
-
-
-
Locate the layer fan adapter (In this kits this part is white, not black as shown), and insert an M3 nut into the slot on it as shown.
-
