You're viewing a previously published revision of this guide. View latest revision

Mar 11, 2022 - 09:03:38

Apr 04, 2022 - 07:04:39 Apr 04, 2022 - 07:04:39 Apr 04, 2022 - 06:04:57 Mar 31, 2022 - 09:03:06 Mar 23, 2022 - 06:03:39 Mar 23, 2022 - 06:03:40 Mar 11, 2022 - 10:03:57 Mar 11, 2022 - 10:03:25 Mar 11, 2022 - 10:03:40 Mar 11, 2022 - 10:03:59 Mar 11, 2022 - 10:03:09 Mar 11, 2022 - 10:03:10 Mar 11, 2022 - 10:03:07 Mar 11, 2022 - 10:03:06 Mar 11, 2022 - 10:03:51 Mar 11, 2022 - 10:03:49 Mar 11, 2022 - 10:03:43 Mar 11, 2022 - 10:03:02 Mar 11, 2022 - 09:03:16 Mar 11, 2022 - 09:03:17 Mar 11, 2022 - 09:03:38 Mar 11, 2022 - 09:03:38 Mar 11, 2022 - 09:03:06 Mar 11, 2022 - 09:03:52 Mar 11, 2022 - 09:03:38 Mar 11, 2022 - 09:03:53 Mar 11, 2022 - 09:03:00

Newer

K) Y Carriage

Written By: Ben Withem (and one other contributor)

Comments: 0
Favorites: 0

Difficulty

Moderate

Steps

Time Required

Suggest a time??

Tools

No tools specified.

Parts

Step 1 K) Y Carriage

Remove the wiring that comes pre-installed on the bltouch by disconnecting the connector. The kit wiring harness has a connector, these wires are not needed.

Put (2) m3 x 2 socket head screws pointing up through the holes in the BLTouch.

Remove the wiring that comes pre-installed on the bltouch by disconnecting the connector. The kit wiring harness has a connector, these wires are not needed.
Put (2) m3 x 2 socket head screws pointing up through the holes in the BLTouch.
Thread a brass insert down on the bolt, tight against the BLTouch.
Pass the bolt up through the BLTouch mount.
Put a single M3 washer on each screw, and then an M3 nylock nut.
Attach the BLTouch mount to the printed Y carriage using (2) M3 x 8 socket head screws.