Difficulty
Moderate
Steps
4
Time Required
In Progress
This guide is currently being written. Reload periodically to see the latest changes.
User-Contributed Guide
This guide is not managed by the site's staff.
Private
This guide will not appear in search results and can only be viewed by team members!
Introduction
It's assumed that you're building a kit from Filastruder, and you've completed all previous sections. At the end of this section you should have a complete frame assembled for your RailCore.
-
-
Use (1) M3 x 8mm Socket Cap Head Screw to attach each of the (4) 270mm upright extrusions to the corner cubes on the bottom frame assembly. Note: It can be helpful to prop the bottom frame assembly up on some old filament spools so that the upright extrusions remain vertical.
-
-
-
Insert acrylic spacers in all extrusion channels facing the outside of the frame. Each extrusion has two outer facing channels.
-
In the layout shown in the second image, insert the acrylic spacer inserts and M3 nuts in all 8 of the outer facing channels. There should be (2) 5mm spacers, (3) 81mm spacers, and (4) M3 nuts in each channel.
-
Insert (2) M3 nuts in each of the remaining 8 channels.
-
-
-
Use (4) M3 x 8mm Socket Cap Head Screws to attach the top extrusion assembly to the upright extrusions.
-
-
-
Insert wisdom here.
-
