Skip to main content
/

Site Navigation

Your Account

Choose Language

  1. Remove backing revealing 3M adhesive and install the silicon heater as shown in the image. Remove backing revealing 3M adhesive and install the silicon heater as shown in the image.
    • Remove backing revealing 3M adhesive and install the silicon heater as shown in the image.

  2. The bolt stack for mounting the bed is made up of (1) M3 x 25 socket head screw, (1) set of leveling washers, (1) 1/4" rubber washer, (1) M3 washer, and (1) nylock M3 nut. The socket head should go in the milled cutout of the bed, and the bed should sit on the stack of the leveling washers on top of the Z yoke. The rubber washer, M3 washer and M3 nylock nut will be below the Z yoke.
    • The bolt stack for mounting the bed is made up of (1) M3 x 25 socket head screw, (1) set of leveling washers, (1) 1/4" rubber washer, (1) M3 washer, and (1) nylock M3 nut.

    • The socket head should go in the milled cutout of the bed, and the bed should sit on the stack of the leveling washers on top of the Z yoke.

    • The rubber washer, M3 washer and M3 nylock nut will be below the Z yoke.

    • The latest version of the Z yokes have three slots. To match the kit configuration, attach the bed to the yokes using the mounting slots closest to the front of the printer.

    • Wiring should hang off the right side of the bed when installed.

    • Tighten the nylock nuts, attaching the bed to the three Z yokes.

Finish Line

One other person completed this guide.

Ben Withem

Member since: 01/02/2022

10,391 Reputation

19 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 3

All Time: 31