Difficulty
Moderate
Steps
3
Time Required
- D) Bottom Extrusions Assembly 3 steps
In Progress
This guide is currently being written. Reload periodically to see the latest changes.
User-Contributed Guide
This guide is not managed by the site's staff.
Private
This guide will not appear in search results and can only be viewed by team members!
Quiz
0
Introduction
It's assumed that you're building a kit from Filastruder, and you've completed all previous sections. At the end of this section you should have a "bottom extrusions" assembly together for your RailCore frame.
-
-
Layout Bottom Frame as shown. Note that the corner cubes should have a small hole facing up.
-
It is a good idea to mark each extrusion with a bit of masking tape on top, indicating which extrusion it is.
-
-
-
Use (1) M3 x 8mm socket cap head screw to the 270mm bottom left extrusion. Note the orientation of the corner cube.
-
-
-
Add Hardware to Bottom Left Extrusion
-
