Help
Carlos Daniel Stagnaro
@daniels
Carlos Daniel Stagnaro
| 1 | Reputation |
|---|---|
| 0 | Guides |
| Member Since 09/24/2020 | |
| 1 | Reputation |
|---|---|
| 0 | Guides |
| Member Since 09/24/2020 | |
AGAIN…Remember to check the voltage!! The power brick comes preset at 220V for safety. In the USA nominal voltage is 110 V. When you give power to the printer later on nothing will happen. Make sure you check the voltage before assambly.
HDPE base on the Printed Solid kit presents holes slightly misaligned. That brings stress to the overall construction. Upgrade to Metal base is highly recommended. All missalignment and lack of squareness went away.