Difficulty
Moderate
Steps
5
Time Required
In Progress
This guide is currently being written. Reload periodically to see the latest changes.
-
-
It can be tempting to rush ahead - you're almost done, after all, and you want to see your printer print. Don't rush these steps.
-
Read each step carefully, and follow the instructions closely, you'll save yourself a lot of time and headache.
-
If at any point you feel over your head here, stop and ask questions in the RailCore Discord (Best option) or RailCore Facebook group.
-
-
-
Your Duet comes with an SD Card pre-loaded with configuration files. We need to change those to the RailCore default files.
-
Remove the SD card and put it in your PC. On it you'll find a series of folders.
-
Make a copy of the "sys" folder, and call it "sys_original".
-
Copy all of the files from here into your sys folder, overwriting the original files: https://www.dropbox.com/sh/dmguq264vp7aw...
-
Copy the files here into the /macros folder: https://www.dropbox.com/sh/gp2ur784zapus...
-
-
-
Before Powering on the first time, You need to connect to your duet with a USB cable.
-
Follow the instructions here for getting connected to your Duet. You can use YAT as suggested, or any other serial console program.
-
Don't worry about upgrading your firmware yet, but take note of the version installed.
-
-
Send an M115 command to your Duet, be sure you see "Duet 2 WiFi + Duex 5" in the output.
-
Continue following the instructions to get the Duet connected to your network.
-
Validate you can reach your Duet via Duet Web control before disconnecting the USB. When you unplug the USB the duet will lose power.
-
-
-
Insert wisdom here.
-
-
-
Insert wisdom here.
-
