Thomas Müller

How square is square enough? When measuring I got the following readings.

Back

- Top left: 90.2 °

- Top right: 90 °

- Bottom left: 89.9 °

- Bottom right: 90.05 °

(so not totally precise)

Front

- Top left: 90.15 °

- Top right: 89.9 °

- Bottom left: 89.85 °

- Bottom right: 90.15 °

(relatively precise it seems)

Measuring the sides is a bit tricky as my angle ruler is colliding with the Z extrusions but it looks OK to me. The left side panel protrudes ~0.3 mm above the top left extrusion in the area to the back (front area is fine). Loosening up the nuts did not really help.

Is this fine or should all angles read exactly 90 °? I know this would be best… not sure if it is even possible.

Thanks!