Skip to main content
/

Site Navigation

Your Account

Choose Language

Help

Step Type:

Drag to rearrange

Remove the wiring that comes pre-installed on the bltouch by disconnecting the connector. The kit wiring harness has a connector, these wires are not needed.

Put (2) m3 x 20mm Button Head Bolts pointing up through the holes in the BLTouch.

Thread a brass insert down on the bolt, tight against the bltouch.

Pass the bolt up through the BLTouch mount

Put an m3 washer on the bolt, and then an m3 Nylock Nut.

Your contributions are licensed under the open source Creative Commons license.