If you have a Halo, now is the time to install it. Generally use (1) M3 x 10mm button head bolt bolt and (1) M3 washer per "slot" in the Halo.
Center the bolt in the middle slot, and put the bolts in the outside slots at the outside ends of the channels.
Be sure to roughly balance the number of M3 nuts between the bolts holding down the Halo.
The Stepper Mounts for the Halo go on the right side of the printer, idler mounts to the left.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.