Now is when you want to square up your frame. Start with the bottom panel, and get it as centered and even as you can.
With the printer laying on its back. Tighten all 5 nuts (including the feet) along one side of the bottom panel. Use a square or 123 blocks to square up the bottom extrusions, and tighten down the rest of the nuts on the bottom panel.
Repeat this process for each of the side panels, tightening the bolts along the bottom of each panel first.
Be sure the side panels do not protrude above the top extrusions before tightening them.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.