Skip to main content
/

Site Navigation

Your Account

Choose Language

Help
Editing Step 6 —

Step Type:

Drag to rearrange

Lay the printer back side down.

The "textured" side of the front HDPE panel should face out, shiny side in.

The thinner edge of the front panel goes towards the top of the printer.

Install the front panel using (20) M3 Nylock Nuts, in the same method as before. Do not fully tighten the nuts yet.

For the ZLT you'll need (24) M3 Nylock Nuts total.

Your contributions are licensed under the open source Creative Commons license.