Skip to main content
/

Site Navigation

Your Account

Choose Language

Help
Editing Step 4 —

Step Type:

Drag to rearrange

Lay the printer Right side down on some blocks to protect the bolts.

It's important that this panel goes on the left end of the printer, which is the end with two Z towers.

The "textured" side of the HDPE panel should face out, shiny side in.

Install the left panel using (20) M3 Nylock Nuts, in the same method as before. Do not fully tighten the nuts yet.

For the ZLT you'll need (24) M3 Nylock Nuts total.

Your contributions are licensed under the open source Creative Commons license.