Skip to main content
/

Site Navigation

Your Account

Choose Language

Help
Editing Step 3 —

Step Type:

Drag to rearrange

Lay the printer front down on some blocks to protect the bolts.

It's important that when looking down at the printer as in the picture, the two Z towers are on the Right side of the image.

The "textured" side of the HDPE panel should face out, shiny side in.

Install the back panel using (20) M3 Nylock Nuts, in the same method as before. Do not fully tighten the nuts yet.

For the ZLT you'll need (24) M3 Nylock Nuts total.

Your contributions are licensed under the open source Creative Commons license.