Help
Editing Step 1 —

Step Type:

Drag to rearrange

Before you anything to the Y carriage, double check that all the brass inserts are in.

Remove the wiring that comes pre-installed on the bltouch by disconnecting the connector. The kit wiring harness has a connector, these wires are not needed.

Put (2) m3 x 2 socket head screws pointing up through the holes in the BLTouch.

Thread a brass insert down on the bolt, tight against the BLTouch.

Pass the bolt up through the BLTouch mount.

Put a single M3 washer on each screw, and then an M3 nylock nut.

Attach the BLTouch mount to the printed Y carriage using (2) M3 x 8 socket head screws.

Your contributions are licensed under the open source Creative Commons license.