To insert the Y rail into the X carriages it gets oriented as in the image. Be sure the "inside' faces with the text milled into them face each other. The line engraved in the linear guide block should be facing up (this should also put any laser engraved text right side up) take a moment to ensure all 3 rails are oriented correctly.
There is a round metal spacer that goes between the Y rail and the horizontal part of the carriage. Lightly tighten the horizontal M3 bolt to hold it in place.
There is a flat aluminum spacer that goes under the Y rail. Lightly tighten vertical bolt under the Rail against that spacer.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.