Slide (6) M3 x 16mm hex head bolts into the top channel.
Slide (5) M3 x 10mm hex head bolts into the outside channel.
Slide (4) M3 nuts into the inside channel. Note: If using a metal bottom (base plate), these are not needed.
In the bottom channel the order is (1) M3 x 16mm head head bolt, (3) M3 x 10mm hex head bolts, (1) M3 x 16mm hex head bolts. It is very important they're in this order, the longer bolts on the end are for attaching the feet.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.