Hold the extrusion as it will be oriented on the printer (make sure the big hole on the corner cube faces up).
In the layout shown in the image, insert the acrylic spacer inserts and M3 nuts in the outer channel. There should be (2) 5mm spacers, (3) 81mm spacers, and 4 M3 nuts.
Slide (7) M3 nuts into the top channel.
Slide (4) M3 nuts into the top channel.
Note on the corner cube, the small hole is pointing to the right in this image.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.