A common request is to increase the speed the Z axis homes. Be careful with this change, you can damage your printer.
Edit the config.g file and find the following line
M558 P9 X0 Y0 Z1 H5 F50 T6000 A5 S0.02
Change the "F50" value to a higher value to increase the speed. "F100" is twice as fast.
A value of F150 should suffice without being too fast to break anything if homing is already confirmed working.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.