Skip to main content
/

Site Navigation

Your Account

Choose Language

Help

Step Type:

Drag to rearrange

Attach the PTFE guide tube to the extruder input, and pass the other end through the PTFE holder on the right side of the printer.

Set your hotend to an appropriate temperature for your filament.

Feed some filament in through the feed tube, until it reaches the extruder.

Using the DWC interface, slowly extrude some filament, it should grab the filament and pull it in.

If instead it pushes the filament back out, find this line in your config.g and change the S0 to an S1

M569 P3 S0

Your contributions are licensed under the open source Creative Commons license.