Skip to main content

Site Navigation

Your Account

Choose Language

Editing Step 6 —

Step Type:

Drag to rearrange

E3D strongly recommends tightening your nozzle while hot.

To do so, after you've PID tuned, run the following to allow your hotend to go above 280C

M143 S295

Run this to set your hotend to 285C, or set it in the DWC interface

M104 S285

Once your hotend is at 285C carefully tighten the nozzle

Once tightened, turn off your hotend in Duet Web Control

Your contributions are licensed under the open source Creative Commons license.