E3D strongly recommends tightening your nozzle while hot.
To do so, after you've PID tuned, run the following to allow your hotend to go above 280C
Run this to set your hotend to 285C, or set it in the DWC interface
Once your hotend is at 285C carefully tighten the nozzle
Once tightened, turn off your hotend in Duet Web Control
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.