You can break your printer with this step, be cautious.
Run this command to allow movement beyond what the printer is physically capable:
M208 X400 Y400 Z700
Use the jog buttons in duet web control to slowly jog the hotend to max Y. Stop just before it hits the rear X carriage, and record the value.
Use the jog buttons in duet web control to slowly jog the hotend to max X, near a leadscrew. Stop before it contacts a leadscrew with the fan. Record the X value.
Use the jog buttons in duet web control to slowly move the bed down by increasing the Z height. Stop before the bed contacts the Z couplers, and record the Z height.
Jog the bed back up, and center the hotend.
Find this line in your config.g and replace the values with the ones you recorded: M208 X290 Y290 Z280
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.