Home all 3 axis, and level the bed. Run G32 at least 3 times, so your bed is as level as it can be.
Run G28 Z to return to the center of the bed. Your bed will move to Z10.
Run the following gcode, so we can move below Z0 if needed:
Place a sheet of paper on your bed.
Using the jog buttons in duet web control, slowly jog down until your nozzle just contacts the paper (slide the paper around until you can feel the nozzle touching it. Use the smallest steps as you get close)
Remove the piece of paper, and run the "Probe Point" macro (click on the macro and it will ask you if you want to run it)
The printer will re-home Z, stopping when the probe triggers.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.