Attach Linear rail to Top Front and Top Back Extrusions by sliding the M3 nuts into the inside channel on the extrusion.
Roughly center the extrusion, and then snug up the bolts.
Do not overtighten the bolts, you just need them snug for now. They'll be tightened later.
It is highly recommended to use a bit of masking tape to keep the carriage from sliding off of the linear rail.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.