In the console for Duet Web Control, issue this gcode:
It should return "Endstops - X: not stopped, Y: not stopped, Z: no endstop, Z probe: not stopped"
Hold in the button on the Y endstop switch (the one near the hotend) and run M119 again.
You should now get "Endstops - X: not stopped, Y: stopped, Z: no endstop, Z probe: not stopped"
If the Y endstop does not show as stopped, check your Y endstop wiring.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.