In the console for Duet Web Control, issue this gcode:
It should return "Endstops - X: not stopped, Y: not stopped, Z: no endstop, Z probe: not stopped"
Hold in the button on the X endstop switch (the one to the rear left of the printer, and run M119 again.
You should now get "Endstops - X: stopped, Y: not stopped, Z: no endstop, Z probe: not stopped"
If none of the endstops show as stopped, check your X endstop connection
If the Y endstop shows as stopped, you have the endstops in the wrong ports. Power down and double check they're plugged in correctly.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.