Loosen all the bolts holding your linear rail to one Z extrusion. Adjust the Rail so it's 20mm above the bottom panel.
Tighten only the top bolt holding the rail to the extrusion.
Place the Rail Alignment Tool over the linear rail near the bottom bolt. This will center the linear rail on the extrusion. Tighten the bottom bolt.
Loosen the top bolt. Now work your way up from the bottom, putting the rail alignment tool near each bolt, then tightening it.
Repeat this process for each of your Z rails.
Repeat this process for your X rails, working end to end. Center the X rails in the extrusion.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.