Prepare the anti-backlash nut for mounting onto the leadscrew.
Thread the bottom half (with the flange) down onto the screw until just the teeth are sticking up past the end of the leadscrew.
Put the spring on the bottom of the leadscrew nut and hold it there until the next step.
Insert the top of the leadscrew nut, pushing down until the teeth in the upper and lower parts interlock.
Thread the nut assembly onto the leadscrew, until it's about 1/3 of the way down.
Repeat the above steps for the other (2) leadscrews.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.