Place the bowden coupler in the BMG mount
Slide the bowden tube onto the PTFE, and fit the BMG into the extruder mount
Trim down the ptfe slightly, until the BMG fits correctly in the mount - You want the ptfe tube as long as possible, so it's fully seated in both the hotend, and the BMG. The PTFE should end up with around 41mm sticking out of the hotend)
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.