Skip to main content

Changes to Step #6

Edit by Ben Withem

Edit approved by Ben Withem

Before
After
Unchanged

Step Lines

[title] Add Hardware into Bottom Front and Bottom Rear Extrusions
-[* black] Insert wisdom here.
+[* black] In the layout shown in the third image, insert the acrylic spacer inserts and M3 nuts in the outer channel of the bottom rear extrusion. There should be (2) 5mm spacers, (3) 81mm spacers, and (4) M3 nuts.
+[* black] In the layout shown in the third image, insert the acrylic spacer inserts and M3 nuts in the bottom channel of the bottom rear extrusion. There should be (2) 5mm spacers, (3) 81mm spacers, and (4) M3 nuts.
+[* black] Slide (2) M3 x 10mm hex head bolts in the top channel of the bottom rear extrusion.
+[* black] Slide (2) M3 x 10mm hex head bolts in the inside channel of the bottom rear extrusion.
+[* black] In the layout shown in the third image, insert the acrylic spacer inserts and M3 nuts in the outer channel of the bottom front extrusion. There should be (2) 5mm spacers, (3) 81mm spacers, and (4) M3 nuts.
+[* black] In the layout shown in the third image, insert the acrylic spacer inserts and M3 nuts in the bottom channel of the bottom front extrusion. There should be (2) 5mm spacers, (3) 81mm spacers, and (4) M3 nuts.
+[* black] Slide (2) M3 x 10mm hex head bolts in the inside channel of the bottom front extrusion.
+[* black] Slide (2) M3 x 10mm hex head bolts in the inside channel of the bottom front extrusion.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added