Skip to main content

Changes to Step #8

Edit by Ben Withem

Edit approved by Ben Withem

Before
After
Unchanged

Step Lines

[title] Attach Linear rail to Top Front and Top Back Extrusions
-[* black] Attach Linear rail to Top Front and Top Back Extrusions by sliding the M3 nuts into the inside channel on the extrusion.
+[* black] Attach each linear rail to top front and top back extrusions by sliding the M3 nuts into the inside channel on the extrusion.
[* black] Roughly center the extrusion, and then snug up the bolts.
[* icon_caution] Do not overtighten the bolts, you just need them snug for now. They'll be tightened later.
-[* icon_caution] It is highly recommended to use a bit of masking tape to keep the carriage from sliding off of the linear rail.