Skip to main content

Changes to Step #3

Edit by Ben Withem

Edit approved by Ben Withem

Before
After
Unchanged

Step Lines

[title] Add Hardware to Top Left Extrusion
-[* black] Hold the Extrusion as it will be oriented on the printer (make sure the big hole on the corner cube faces up).
+[* black] Hold the extrusion as it will be oriented on the printer (make sure the big hole on the corner cube faces up).
[* black] In the layout shown in the image, insert the acrylic spacer inserts and M3 nuts in the outer channel. There should be (2) 5mm spacers, (3) 81mm spacers, and 4 M3 nuts.
[* black] Slide (7) M3 nuts into the top channel.
[* black] Slide (4) M3 nuts into the top channel.
[* icon_note] Note on the corner cube, the small hole is pointing to the right in this image.