Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #6

Edit by Tony Akens

Edit approved by Tony Akens

Before
After
Unchanged

Step Lines

+[title] Hot Tighten Your Nozzle
+[* black] E3D strongly recommends tightening your nozzle while hot.
+[* black] To do so, after you've PID tuned, run the following to allow your hotend to go above 280C
+ [* light_blue] M143 S295
+[* black] Run this to set your hotend to 285C, or set it in the DWC interface
+ [* light_blue] M104 S285
+[* black] Once your hotend is at 285C carefully tighten the nozzle
+[* black] Once tightened, turn off your hotend in Duet Web Control