Changes to Step #3
Edit by Tony Pavlakis —
Edit approved by Tony Pavlakis
- Before
- After
- Unchanged
Step Lines
| [title] Add Hardware to Top Left Extrusion | |
| [* black] Hold the Extrusion as it will be oriented on the printer (So the big hole on the corner cube faces up) | |
| - | [* black] Slide (8) |
| - | [* black] Slide (5) |
| - | [* black] Slide (4) |
| - | [* black] Slide (6) |
| + | [* black] Slide (8) M3 nuts into the top channel |
| + | [* black] Slide (5) M3 x 10mm Hex Head Bolts in the outside channel |
| + | [* black] Slide (4) M3 nuts in the inside channel |
| + | [* black] Slide (6) M3 x 16mm Hex Head bolts in the bottom channel |
| [* icon_note] Note on the corner cube, the small hole is pointing to the right in this image |