Changes to Step #7
Edit by Tony Akens —
Edit approved by Tony Akens
- Before
- After
- Unchanged
Step Lines
| [title] (2x) Install M3 Hardware into Linear Rail | |
| [* black] Use a bit of masking tape to keep your carriage from sliding off your linear rail. | |
| [* black] Select 4 evenly spaced holes in your linear rail. | |
| - | [* black] Place a lock washer on (1) M3 x 8mm |
| + | [* black] Place a lock washer on (1) M3 x 8mm socket cap head screw, and place it into one of the holes selected. Loosely thread on (1) M3 nut to the bolt. DO NOT TIGHTEN THEM FULLY. The M3 nut only needs to be threaded onto the tip of the bolt, you want a gap between the nut and the back of the rail. Repeat for the other three (3) holes. |
| [* black] Repeat the above steps for the other 400mm rail. | |
| [* icon_caution] It is highly recommended to use a bit of masking tape to keep the carriage from sliding off of the linear rail. |
Image 1
Old Version
New Version