Changes to Step #9
Edit by Tony Akens —
Edit approved by Tony Akens
- Before
- After
- Unchanged
Step Lines
+ | [title] Y Homing Test |
---|---|
[* icon_caution] When running the following commands, a lot can go wrong. Keep your finger near the power switch just in case. | |
[* black] Test Homing Y by running the following in the gcode console: | |
- | [* |
+ | [* light_blue] G28 Y |
[* black] Your hotend should move towards the front of the printer until the Y endstop triggers against the front X carriage. |