Changes to Step #7
Edit by Tony Akens —
Edit approved by Tony Akens
- Before
- After
- Unchanged
Step Lines
[title] BLTouch Testing | |
[* black] Your BLTouch should be on, with a solid red light. If it's flashing, power off and check its wiring. | |
[* black] Run the following gcode in the console in duet web control: | |
[* black] M280 P3 S10 | |
- | [* black] The pin on the bltouch should lower. |
+ | [* black] The pin on the bltouch should lower. (Look across the nozzle of your hotend at the pin, it should extend below the nozzle, this is important for leveling!) |
[* black] Tapping the pin lightly with your fingertip should cause it to retract, then drop back down. | |
[* black] Running the following gcode should retract the pin again: | |
[* black] M280 P3 S90 | |
[* black] The Z Probe value in the duet web control should read zero. |