Changes to Step #7
Edit by Tony Akens —
Edit approved by Tony Akens
- Before
- After
- Unchanged
Step Lines
| + | [title] BLTouch Testing |
|---|---|
| + | [* black] Your BLTouch should be on, with a solid red light. If it's flashing, power off and check its wiring. |
| + | [* black] Run the following gcode in the console in duet web control: |
| + | [* black] M280 P3 S10 |
| + | [* black] The pin on the bltouch should lower. |
| + | [* black] Tapping the pin lightly with your fingertip should cause it to retract, then drop back down. |
| + | [* black] Running the following gcode should retract the pin again: |
| + | [* black] M280 P3 S90 |
| + | [* black] The Z Probe value in the duet web control should read zero. |