Changes to Step #6

Edit by Tony Akens

Edit approved by Tony Akens

Before
After
Unchanged

Step Lines

+[title] Test Y Endstop
+[* black] In the console for Duet Web Control, issue this gcode:
+ [* black] M119
+[* black] It should return "Endstops - X: not stopped, Y: not stopped, Z: no endstop, Z probe: not stopped"
+[* black] Hold in the button on the Y endstop switch (the one near the hotend) and run M119 again.
+[* black] You should now get "Endstops - X: not stopped, Y: stopped, Z: no endstop, Z probe: not stopped"
+[* icon_caution] If the Y endstop does not show as stopped, check your Y endstop wiring.