Changes to Step #5

Edit by Tony Akens —

Edit approved by Tony Akens

Before
After
Unchanged

Step Lines

[title] Test X endstop
[* black] In the console for Duet Web Control, issue this gcode:
[* light_blue] M119
[* black] It should return "Endstops - X: not stopped, Y: not stopped, Z: no endstop, Z probe: not stopped"
[* black] Hold in the button on the X endstop switch (the one to the rear left of the printer, and run M119 again.
[* black] You should now get "Endstops - X: stopped, Y: not stopped, Z: no endstop, Z probe: not stopped"
-[* black] If none of the endstops show as stopped, check your X endstop connection
-[* black] If the Y endstop shows as stopped, you have the endstops in the wrong ports. Power down and double check they're plugged in correctly.
+[* icon_caution] If none of the endstops show as stopped, check your X endstop connection
+[* icon_caution] If the Y endstop shows as stopped, you have the endstops in the wrong ports. Power down and double check they're plugged in correctly.