Changes to Step #5

Edit by Tony Akens

Edit approved by Tony Akens

Before
After
Unchanged

Step Lines

+[title] Test X endstop
+[* black] In the console for Duet Web Control, issue this gcode:
+ [* light_blue] M119
+[* black] It should return "Endstops - X: not stopped, Y: not stopped, Z: no endstop, Z probe: not stopped"
+[* black] Hold in the button on the X endstop switch (the one to the rear left of the printer, and run M119 again.
+[* black] You should now get "Endstops - X: stopped, Y: not stopped, Z: no endstop, Z probe: not stopped"
+[* black] If none of the endstops show as stopped, check your X endstop connection
+[* black] If the Y endstop shows as stopped, you have the endstops in the wrong ports. Power down and double check they're plugged in correctly.