Changes to Step #3

Edit by Tony Akens

Edit approved by Tony Akens


Step Lines

+[title] Y Stepper Direction
+[* black] This is much the same as the X stepper.
+[* black] In the console window of Duet Web Control, run the following:
+ [* black] G91
+ [* black] G1 H2 Y10 F3000
+[* black] This should move the hotend in the +X and -Y Directions (towards the right side of the printer, and front of the printer)
+[* black] If it does not, find this line in your config.g value, and change the S1 to S0
+ [* black] M569 P1 S1