Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #2

Edit by Chris Longman

Edit approved by Tony Akens

Before
After
Unchanged

Step Lines

[title] X (Rear) Stepper Direction
[* black] These instructions are documented here as well: https://www.duet3d.com/wiki/Configuring_RepRapFirmware_for_a_CoreXY_printer
[* black] Starting with the hotend over the center of the bed, issue the following in the "console" window of the Duet Web Control
[* light_blue] G91
[* light_blue] G1 H2 X10 F3000
-[* black] That should move your Hotend in +X +Y (towards the right and back of the pritner)
+[* black] That should move your Hotend in +X +Y (towards the right and back of the printer)
[* black] If your hotend moves -X -Y (Left and front), find this line in the config.g and change the S0 to S1:
[* light_blue] M569 P0 S0
[* icon_caution] If the Y (front) stepper moves, you have the steppers in the wrong ports. Power Down and change the cables to the correct ports - see the wiring instructions.