-
-
It works best to build the bolt stacks for attaching the bed, then put them in place on the yokes.
-
(Filastruder kits use a Socket Cap Head Screw in place of a button head bolt)
-
On a 20mm Button Head Bolt place:
-
(1) M3 Fender Washer
-
1/4 rubber washer
-
(1) M3 Fender Washer
-
(1) m3 Nylock Nut
-
-
-
Place the bolt stack on the yoke, so the Nylock nut and m3 fender washer are below the Yoke, and the 1/4 rubber washer is on top of the yoke.
-
Repeat for all 3 yokes.
-
The right yoke gets a ground wire from the bed wiring harness above the top washer. (not yet pictured). This requires a 25mm bolt to do as shown, currently the kits ship with only 20mm bolts, leaving out the lower washer is temporary fix.
-
-
-
Install the bed by fitting it onto the yokes, with the best resting on the 1/4 rubber washers, and the m3 fender washer in the grooves on the bed tabs.
-
Snug up the m3 nylock nuts to hold the bed in place.
-
