Difficulty
Moderate
Steps
10
Time Required
- D) Bottom Extrusions Assembly 10 steps
In Progress
This guide is currently being written. Reload periodically to see the latest changes.
Quiz
0
Introduction
It's assumed that you're building a kit from Filastruder, and you've completed all previous sections. At the end of this section you should have a "bottom extrusions" assembly together for your RailCore frame.
-
-
Layout Bottom Frame as shown. Note that the corner cubes should have a small hole facing up.
-
It is a good idea to mark each extrusion with a bit of masking tape on top, indicating which extrusion it is.
-
-
-
Use (1) m3 x 8mm Button head bolt to the bottom left extrusion. Note the orientation of the corner cube.
-
-
-
Slide (6) m3 x 16mm hex head bolts into the top channel.
-
Slide (5) m3 x 10mm hex head bolts into the outside channel.
-
Slide (4) m3 nuts into the inside channel.
-
In the bottom channel the order is (1) m3 x 16mm head head bolt, (3) m3 x 10mm hex head bolts, (1) m3 x 16mm hex head bolts. It is very important they're in this order, the longer bolts on the end are for attaching the feet.
-
-
-
Add Second Corner Cube to Bottom Left Extrusion
-
-
-
Add Bottom Front and Bottom Rear Extrusions
-
-
-
Add Hardware into Bottom Front and Bottom Rear Extrusions
-
-
-
Install Corner Cube on Bottom Right Extrusion
-
-
-
Add Hardware into Bottom Right Extrusion
-
-
-
Add Second Corner Cube to Bottom Right Extrusion
-
-
-
Attach Bottom Right Extrusion to the Rest of the Bottom Frame
-
